Palomar rfx 150 for sale
![palomar rfx 150 for sale palomar rfx 150 for sale](https://www.picclickimg.com/d/l400/pict/173734150682_/Palomar-RFX95HD-10-meter-CB-Radio-RF-Power.jpg)
Mchaos the original set of RFX that came out with no pre installation check list and it was hit and miss on figuring out the problems. With a modded RK56 its sick.Īfter the slight difficulties, its one mean barefoot duck stomping machine. more swing, but raspy.Īt about 3/4 on the mic gain produced devilishly loud audio. If I brought it any lower then 20 watts the audio started to suffer and got raspy. Could probably go a bit more on the carrier, but that's where I got the best forward swing without sacrificing audio. I found that good forward swing was achieved at around 23-25 watts. Once I got far enough away to observe the swing, it was swinging back quite a bit. Had a buddy of mine key it up, with out any swing mod.
![palomar rfx 150 for sale palomar rfx 150 for sale](https://img.directindustry.com/images_di/photo-m2/178472-16319107.jpg)
I found that with out dropping the dead key produced some back swing.
#PALOMAR RFX 150 FOR SALE MOD#
I did tweak it using my mod meter but found turning it way down still produced full swing on the meter. Haven't seen anything else around on the net about this issue.Īlso, with tweaking I was able to get just over 150 watts pep out of mine dead keying about 23-24 watts. Might have been an issue with this particular cobra 29. Grounding the audio transformer pretty much took care of it. I also went around the radio and made sure all the ground points where good. I grounded the audio transformer to the chassis. I made sure to make all wires as short as possible. If any one has this problem, this is what solved it for me. If I turned the gain up past half, I had issues. There is a pre-installation guide, which has things to look for that will cause it not to work, that you can fix before install, and a troubleshooting guide.
![palomar rfx 150 for sale palomar rfx 150 for sale](https://www.bellscb.com/products/accessories/Powerband/images/RFX-85_1.jpg)
On the RFX75 page on cbtricks, there are 2 very handy documents that can help with them not working when new. I had some slight problems at first, but was able to work them out.įirst I would like to through out an FYI.